Records are cut with a frequency response such that when they are replayed with a magnetic pickup and a preamplifier with RIAA equalization (Recording Industry Association of America) the reproduced sound will be as similar to the original as possible.
The disc is cut at constant amplitude, except from 500Hz to 2120Hz where it is cut at constant velocity. When this disc is replayed with a magnetic pickup, the relative output voltage rises with frequency, due to the fact that the magnetically generated voltage is proportional to the velocity of the stylus as it moves sideways in the groove. To restore the original sound quality, a preamplifier with afrequency response that, gives decreasing output with increasing frequency is required. This response curve is known as the RIAA equalization and it is tailored accurately to fit the cutting and replay processes. The signal level from a magnetic pickup is low, generally 20mVpp and so a low noise pre- amplifier is needed.
The circuit shows a realization of this requirement. The low noise amplifier is the LM381 -made by National Semiconductors. A DC bias control is included (RV1, RV2), and the feedback components generate the RIAA curve. Use screened cable for the wiring to the pickup, keep the circuit away from transformers (and the pickup and its wiring) and connect all the earths together, near to the IC.
The disc is cut at constant amplitude, except from 500Hz to 2120Hz where it is cut at constant velocity. When this disc is replayed with a magnetic pickup, the relative output voltage rises with frequency, due to the fact that the magnetically generated voltage is proportional to the velocity of the stylus as it moves sideways in the groove. To restore the original sound quality, a preamplifier with afrequency response that, gives decreasing output with increasing frequency is required. This response curve is known as the RIAA equalization and it is tailored accurately to fit the cutting and replay processes. The signal level from a magnetic pickup is low, generally 20mVpp and so a low noise pre- amplifier is needed.
