| Part | Total Qty. | Description | Substitutions | | R1, R2, R3, R4, R8, R7 | 6 | 100K 1/4W Resistor |
| | R5 | 1 | 470 Ohm 1/2W Resistor |
| | R6 | 1 | 10K Linear Pot |
| | C1 | 1 | 0.01uF Mylar Capacitor |
| | C2 | 1 | 0.1uF Ceramic Disc Capacitor |
| | C3 | 1 | 470uF 63V Electrolytic Capacitor |
| | D1 | 1 | 1N4004 Rectifier Diode |
| | D2 | 1 | BY229-400 Fast Recovery Diode | See Notes | | Q1 | 1 | BC337 NPN Power Transistor |
| | U1 | 1 | LM358 Dual Op Amp IC |
| | L1 | 1 | See Notes |
| | MISC | 1 | Board, Wire, Socket For U1, Case, Knob For R6, Heatsink for Q1 |
|
| |
- R6 sets the output voltage. This can be calculated by Vout = 12 x (R8/(R8+R7)) x (R6B/R6A).
- L1 is made by winding 60 turns of 0.63MM magnet wire on a toroidial core measuring 15MM (OD) by 8MM (ID) by 6MM (H).
- D2 can be any fast recovery diode rated at greater then 100V at 5A. It is very important that the diode be fast recovery and not a standard rectifier.
- Q1 will need a heatsink.
