40W Broadband FM RF Power Amplifier
This constructional techniques results in excellent shielding, preventing RF radiation escaping from the amplifier. Without it, significant amounts of RF radiation could be radiated, interfering with other sensitive circuits such as VCOs and audio stages, also significant amounts of harmonic radiation could occur.
Any RF power amplifier must be followed by a low pass filter (LPF) to reduce the harmonics to an acceptable level. What this level is in a unlicensed application is a moot point, but as the output power is increased, more attention must be be paid to the harmonic suppression.
In this RF power amplifier design used a 7 pole Chebyshev low pass filter. A Chebyshev was chosen as the phase and amplitude ripple within the passband was not critical, and the Chebyshev gives a better stop band attenuation than compared to say, a Butterworth. The design stopband was chosen to 113MHz, giving a 5MHz implementation margin from the highest desired passband frequency at 108MHz and the start of the stopband at 113MHz.
The next critical design parameter was the passband ripple. For a single frequency design it is normal practice to choose a large passband ripple, for example 1dB, and tune the peak of the last passband maxima to the desired output frequency. This gives the best stopband attenuation because greater passband ripple results in more rapid stopband attenuation. A seven pole filter has 7 reactive elements, in this design four capacitors and three inductors. The more poles, the better the stopband attenuation, at the expense of increased complexity and more passband insertion loss. An odd number of poles is required as both the input and output impedance was designed to be 50R.
40W Broadband FM RF Power Amplifier
